Attention! Installation and wiring of electrical installation products must be
carried out by qualified personnel.
The installation and connection of the device must be carried out when the power is disconnected.
Setting up the remote control of Livolo touch switches is according to the manufacturer's instructions.
Connecting the remote control to the switch:
- Touch the active (sensor) area of the switch and hold the finger on the switch for approximately 5 seconds.
Up to playback of a single beep by the switch.
- Press the "A", "B" or "C" (the "D" button has the "Off all" function by default) on the remote control. A single beep indicates that the connection was successful.
- Repeat the procedure to connect each active (sensor) zone of the switch to the corresponding button on the remote control.
Disconnecting the remote control from the switch:
- Touch the active (sensor) area of the switch and hold the finger on the switch for approximately 5 seconds.
Up to playback of a single beep by the switch.
- Press the button on the remote control connected to this switch (active zone). Two continuous beeps mean that the procedure was successful.
Reset all switch settings:
Touch the active (sensor) area of the switch and hold the finger on the switch until a second single audio signal is played (approximately 10 seconds). As a result, all remote controllers connected to it will be disconnected from this line.
Attention! Each active (sensor) area of the switch can be connected to up to eight different remote control buttons at the same time. If you connect the ninth button of the remote control, it will automatically replace the first one.